Tag: plumber

The water heater is an important part of the plumbing system of a home. It ought to be maintained well so that it can last for 10 to 15 years or even more. If Oak Hills CA Water Heaters just like others are not well-maintained, they can fail. Also, the condition of drinking water in your home will be out of control. The following are preventive maintenance tips:

Water heater tips

Preparing the water heater

You can turn off the heater when not in use. Also, turn off water to the heater by closing a valve on the cold line. This is located on top of the heater. In most cases, it is on the right-hand side.

Overhead clearance

The anode rods are tall like the water heater. Also, the ceiling is close to the top of a water heater. You can lift it and check whether there is flaking on the surface and whether the core wire is exposed. If it is not, you can reinstall the anode. The majority of the anode rods issues occur at the top. If it has malfunctioned, it should be removed. Put a new one by bending it at the middle and then straighten it out.

Choosing and replacing anodes

There are three main forms of metals that are used to make the anode rods. These are aluminum, zinc, and magnesium. If you are using soft water, it is advisable to install magnesium anodes. If the previous one has deteriorated, then you should install a new one.

Removing sediment

There are signs which can help you know that there is a lot of sediment buildup in the tank. For instance, if you are using a gas heater, you will hear a lot of noise. Also, if it is an electrical water heater, there will be a lower element burnout. It is advisable to hire a plumber to help resolve this problem. The other option is to dissolve the sediment.

In most water heaters, sediment is picked up and stored in suspension in the water. You can open the drain valve and allow the cold water to enter for about 10 minutes. It will easily clear up the sediment. It is also possible to remove the sediment using a muck vac. You should hire a credible plumber who can use the tool to remove all the sediment from the water heater. This tool is quite expensive, and you have to be skilled in using it.…